Canon Pixma MX320 MX328 Resume Manual Reset

Problems often arise in Printer Canon Pixma cartridges modification is often an error or blink if the original ink runs out. What often happens is still ink in the cartridge full of ink but telling indicator that the ink runs out and there is an error or blink.

What should you do when the Canon Pixma MX320 MX328 blink error is you just need to do a little trick, which is to do "Resume" only. How do I submit a resume Canon Pixma MX320 and MX328?

Canon Pixma MX320 MX328 Resume Manual Reset

Canon Pixma seri IP Resume Manual Reset

• Press the Stop / Reset about 30 seconds. Usually this problem will reset back to normal.

Canon Pixma MP series Resume Manual Reset to above:

• If the alarm indicator light black ink so that you do is: Simultaneously press the Stop / reset and a black button about 30 seconds up to 1 minute.

• If the alarm indicator light color ink so that you do is: Simultaneously press the stop / reset button and color about 30 seconds up to 1menit.

Canon Pixma MX328 Resume Manual Reset

 

A. Canon Pixma MX328 Reset

Step by Step manual reset Printer Canon Pixma MX 328:
1. Turn off the printer, and USB power cable still attached.
2. Press the Stop / Reset, hold, not released about 3 up to 5 second.
3. Press the On / Off, hold for a while do not acquitted, along with the pressure drop on the Stop button / Reset.
4. About 3 second, press the Stop / Reset twice.
5. Then press again the "Stop / Reset" 4 times, the emphasis interval as counting numbers 1,2,3,4. After this process the screen will display the words "SAVE MODE, IDLE", which indicates the printer is 'idle'.
6. Next pressOn Off button twice, a long time the emphasis is the same as above. Printer will turn off.
7. Wait about 1 up to 2 minutes, if the printer does not turn off by itself, turn the printer off by pressing the On / Off button once again.
8. Turn On the printer.

B. Canon Pixma MX328 Resume

For printers with the MP series, usually after the reset, problem solved. Canon Pixma MX328 but you have to do "resume", as follows:
1. Try to use a printer that has been reset to try to test print a document. If the printing process stops it will be displayed "Error" on the display with the indicator "Jammed Paper". It is a command to eject the paper stopped, and there was a black or color ink writing in "Low".
2. Do a resume: press the Stop / Reset simultaneously for 5 seconds.
3. Try another test print new documents. See, the Canon Pixma MX328 working again without buying a new Cartidge.

If the problem Canon Pixma MX320 MX328 Resume Manual Reset still occurs, you can try the software resetter Canon Pixma MX320/MX328